ceramic waste as coarse aggregate and quarry dust as fine aggregate

An Experimental Study on Replacement of Cement with Fly Ash, Fine Aggregate

An Experimental Study on Replacement of Cement with Fly Ash, Fine Aggregate with Graded Quarry Dust and Coarse Aggregate with Ceramic Waste Tiles in Concrete This edition was published in 2017 by ASDF International in Karur, India.

PDF Vol. 5, Issue 4, April 2016 Experimental Study of Coarse

5. So In the further investigation 30 % replacement of ceramic waste as coarse aggregate and quarry dust as fine aggregate (sand) by conventional aggregates content in concrete can be optimized. 6. In the further investigation the combined effect of 40% replacement of coarse aggregates with ceramic waste and 15%, 30%, and 45% replacement of ...

Experimental Analysis on Concrete by Partial Replacement of

Ceramic tile waste is found as an effective alternate and supplementary material in concrete with the optimum replacement of 40%. (Hitesh Kumar, et al., Aug 2015) [8].The optimum percentage of concrete with ceramic tile waste for coarse and fine aggregate is 10% & 20% (Hemnath Kumar ch.et al., June 2015) [9].

PDF) Concrete With Ceramic Waste And Quarry Dust Aggregates

This research focuses on a study of the strength of concrete with ceramic waste as coarse aggregate and quarry dust as fine aggregate. The sources of ceramic waste and quarry dust are obtained ...

Influence of Coarse Aggregate on the Physical and Mechanical

using plastic waste, coarse aggregate, quarry dust and ceramic waste have shown better result. Gawande et al. [5] successfully investigated the partial replacement of bitumen by waste plastic as binder for the purpose of roads and flexible pavement. Dinesh et al. [2] also shows that plastic waste can

PDF Performance of Recycled Ceramic Waste as Aggregates in

Performance of Recycled Ceramic Waste as Aggregates in Asphalt Mixtures 240 A crushed coarse and fine aggregate with a maximum size of 14 mm was selected for a dense graded asphalt mixture. The gradation and the corresponding mix designations for HMA mixture together with PWD specification limits are shown in Fig. 2.

PDF Ceramic Waste : Effective Replacement Of Cement For

d) Coarse Aggregate The fractions from 20 mm to 4.75 mm are used as coarse aggregate. The Coarse Aggregates from crushed Basalt rock, conforming to IS: 383 is being use. The Flakiness and Elongation Index were maintained well below 15%. e) Fine aggregate Those fractions from 4.75 mm to 150 microns are termed as fine aggregate.

Concrete with ceramic and granite waste as coarse aggregate

Aug 29, 2020 · Materials utilized in this work incorporates concrete, fine aggregate, coarse total earthenware and rock waste. Ceramic and rock squander utilized are appeared in Fig. 1, Fig. 2. Cement utilized was conventional Portland bond from ultra tech with particular gravity 3.12 fine total which goes under zone II according to IS 383-1970.

IOP Conference Series: Materials Science and Engineering PAPER

Various industrial waste materials like quarry dust, glass powder, ceramic dust and coal dust are used as partial replacement of fine aggregate and assessed the strength parameters and compared the profit percentages after replacement with waste materials.

Concrete with ceramic and granite waste as coarse aggregate

Materials utilized in this work incorporates concrete, fine aggregate, coarse total earthenware and rock waste. Ceramic and rock squander utilized are appeared in Fig. 1, Fig. 2.Cement utilized was conventional Portland bond from ultra tech with particular gravity 3.12 fine total which goes under zone II according to IS 383-1970.

Literature Review on Different Waste Materials Use in Concrete

The potential of recycled ceramic waste as a substitute for coarse aggregates in concrete has been investigated. The recycle ceramic waste as aggregate was used. Concrete mixes with a 28 days characteristic strength of 20 MPa had prepared using water/cement ratio of 0.4, 0.5 and 0.7. The strength development of the concrete mixes containing ...

Utilization of Construction Waste Tiles as a Replacement for

This study is an investigation into the utilization of waste tiles as partial replacement for fine and coarse aggregates in concrete. The control mix and other mixes containing cement, water, granite and partial replacement for sand with crushed tiles (in 5%, 10%, 15% and 20% proportions) were cast, cubed, cured and crushed.

PDF) Concrete with ceramic waste and quarry dust aggregates

In general, ceramic waste aggregate showed the properties closed to those of natural crushed stone aggregate. 5.2 Properties of ceramic waste coarse aggregate concrete and quarry dust fine aggregate concrete The properties of ceramic waste coarse aggregate and quarry dust fine aggregate concrete are presented in Table 2.

Review on Performance of Quarry Dust as Fine Aggregate in

2020. 9. 8. · coarse aggregate by ceramic scraps. Safiuddin et al,also have tried the partial replacement of sand with quarry dust in fly ash/silica fume based concrete and concrete having 20% sand replaced with quarry dust and 10% weight replacement of cement with flyash and same 10% weight replacement of cement with silica fume

PDF Literature Review on Different Waste Materials Use in Concrete

The potential of recycled ceramic waste as a substitute for coarse aggregates in concrete has been investigated. The recycle ceramic waste as aggregate was used. Concrete mixes with a 28 days characteristic strength of 20 MPa had prepared using water/cement ratio of 0.4, 0.5 and 0.7. The strength development of the concrete mixes containing ...

compressive strength of quarry waste as coarse aggregate in concrete

Concrete With Ceramic Waste And Quarry Dust Aggregates. determine the strength of concrete with ceramic waste coarse aggregate and quarry dust fine ... Keyword: Ceramic Waste; Quarry Dust; Compressive Strength. 1. Read more

Characterization of ceramic waste aggregate concrete

Thus, the current study focuses on the mechanical characterization of waste ceramic wall and floor tiles aggregate concrete. Ceramic wastes sourced from construction and demolition wastes were separated from other debris and crushed using a quarry metal hammer. Ceramic tiles were sieved into fine and coarse aggregates in line with standards.

Effect of fine ceramic recycled aggregate (RA) and mixed fine

Natural quarry aggregates The raw crushed aggregates used in the experimental phase were fine aggregate (FA 0–4 mm), coarse aggregate type 1 4–12 mm (CA1) and coarse aggregate type 2 12–20 mm (CA2) from a limestone quarry. Densities and absorption were determined according to UNE EN 1097-6:2001 and are presented in Table 2.

compressive strength of quarry waste as coarse aggregate

Strength of concrete with ceramic waste and quarry dust as aggregates ... replacement for conventional crushed stone coarse and fine aggregate. Experiment ... From the results show that compressive strength of concrete with quarry dust as...

A STUDY ON PROPERTIES OF CONCRETE WITH CERAMIC WASTE REPLACED

Hence the fine aggregate can be replaced fully or partially by materials like M-sand, quarry dust, saw dust, rice husk ash, ceramic waste etc in concrete. Ceramic waste may be used as an alternative for natural sand.

Experimental Study of Partial Replacement of Fine Aggregate

In the present study various tests on material such as cement, fine aggregate, coarse aggregate and the waste material from china clay industries were performed as per the Indian Standards. Material Used 1. Fine aggregate: a) Sand: River sand was used as fine aggregate. The size of the sand used is 4.75 mm and down size. The properties of

Introduction to Quarry-Dust as Partial Replacement Material

quarry dust as fine aggregate: effect on compressive strength , durability and workability of concrete. The experimental study done by R Chandana Sukesh, Katakam Bala Krishna, P.Sri Lakshmi Sai Teja, S.Kanakambara Rao.[6] in which replacement of the sand with quarry dust shows an improvement in the compressive strength of the concrete.

Ceramic Waste : Effective Replacement Of Cement For Establishing

Can ceramic waste be used in concrete?

PDF Studies on Strength Characteristics on Utilization of

industrial waste materials such as fly ash, blast furnace slag, quarry dust, tile waste, brick bats, broken glass waste, waste aggregate from demolition of structures, ceramic insulator waste, etc. have been tried as a viable substitute material to the conventional materials in concrete and has also been succeeded. This paper describes

Utilization of Stone Dust as Fine Aggregate Replacement in

2015. 4. 30. · coarse aggregate I. INTRODUCTION – Concrete is commonly used construction material due to its ease of availability, mouldable, rigidity and durability. It consists of binding material, fine aggregate, coarse aggregate and required quantity of water, where sand is normally used as fine aggregate.

Leave a Comment